Door Box

[MBA786]

Our ATA Poly 400 is provisioned and registered with Zoom. I connected the ATA's phone port to the door box after provisioning. I press the button on the door box after connecting, but nothing happens. The receptionist should be able to hear it, but it's not. I believe that in order for the receptionist's phone to ring, the ATA must be set up for Ring Down.

Could someone please tell me how to set up the Ring feature on the receptionist's phone?

[Eliot]

hi mba786,

you need to configure the ata's digitmap to auto dial your receptionist's extension when your door box button is pressed causing the line to go off-hook.

From hp and 8x8

Help Center - How to Set Up Obihai Off-Hook Autodial

See also hp/poly admin guide page 80 for hot line syntax and examples on page 82.

<:1234> - Matches an empty phone number and replaces with 1234. This is the

syntax for a hotline to 1234.

 <S0:1234> - Equivalent to the last example.

 <:#> - Hotline to the number #.

 <S0:#> - Equivalent to the last example

Poly ATA 400 Series Administrator Guide PVOS-L ATA 4.0.1

Did my response answer your question? If so, please don't forget to mark the reply as an accepted solution.

thanks,  eliot

[sparrow]

I would caution on configuring local settings on the ATA. I suggest you test to see if it get's overwritten by Zoom provisioning. I had a similar need and used a Cisco ATA 192 (MPP). After applying the hotline dial plan mapping, the device kept rebooting and going back to the default mapping. I decided to use a Zoom template to push the dial plan mapping and it stuck. That basically implies that Zoom overrides the dial plan mapping. Alternatively, door boxes might have a local setting within its own programming to send the digits rather than using the ATA to do it. The ATA is still needed but it's the device configured for ring down in this case.