Room Controls for USB-to-Serial adapter

[PatDuss]

Hello,

I'm writing a JSON file for room controls and can't seem to find any documentation around sending commands via USB-to-Serial adapter. I did, however, see that this capability was added in a past update so it should be possible.

I know that my USB adapter is using COM3 but was not 100% on how to reference it in the JSON file. I am getting a Json File Configuration error.

I was hoping if someone could let me know if I am on the right track here and offer any suggestions.

Here is what I have for the adapters section:

"adapters": [

{

"model": "Serial_Port",

"port": "COM3",

"settings":

{

"baud_rate": "9600",

"data_bits": "8",

"parity": "PARITY_NONE",

"stop_bits": "1",

"flow_control": "FLOW_NONE"

 },

(if you would rather I post the entire JSON file I can I was just focusing on the adapter for this post)

Thanks!