Polycom phones need to connect to VLAN 60 only, not the primary network, VLAN 1

[sachinzoom]

Hello @jcoyle 

You can do this using provisioning templates:

https://support.zoom.us/hc/en-us/articles/360035817952-Configuring-desk-phone-provision-templates

It will lead you to this Poly article, which explains the parameters to be set in the provisioning templates:

https://community.poly.com/t5/VoIP-SIP-Phones/FAQ-Utilizing-VLAN-s-with-Polycom-phones/td-p/38100

If this response helps, please accept the answer as an accepted solution, so others can benefit as well.

[enielsen]

I'm pretty sure that the preferred way is to do this on your switches if you have managed switches that support protocols like LLDP, then a phone can never end up on a non-voice VLAN due to phone configuration issues.