cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

On April 16, between 2:25 P.M. ET and 4:12 P.M. ET, the domain zoom.us was not available due to a server block by GoDaddy Registry. This block was the result of a communication error between Zoom’s domain registrar, Markmonitor, and GoDaddy Registry, which resulted in GoDaddy Registry mistakenly shutting down zoom.us domain. Zoom, Markmonitor, and GoDaddy worked quickly to identify and remove the block, which restored service to the domain zoom.us. There was no product, security or network failure at Zoom during the outage. GoDaddy and Markmonitor are working together to prevent this from happening again.

Provisioning Template Parameters for Yealink MP-series - Zoom Phone Appliances

SilentDogood
Newcomer
Newcomer

‎2024-03-26 01:45 PM - edited ‎2024-03-26 01:45 PM

As the topic describes;   Does anyone have a parameter guide document for Yealink MP series phones?

Looking to build device provisioning templates for these phones.  However, there doesn't seem to be any documentation out there.   The Yealink T-series has a guide,  but the parameters given in that doc are not working.

For example,  looking to enable the Web Admin GUI, by default,   for MP-series devices.

 

Thanks in advance.

0 Likes
1 REPLY 1

haydn
Newcomer
Newcomer

‎2024-08-08 07:08 PM - edited ‎2024-08-08 07:26 PM

These parameters are defined and implemented by the Yealink team. You can contact them to get the most accurate parameters. But if the device web interface has settings you want to change, you can find them on the page. For example, if you want to change mp56 to IPv6, you can access the device web interface. Go to Basic -> Internet Port -> Mode (IPv4/IPv6) -> Click the ? after seeing to see the parameters and allowed values:

Description:
1.It configures the IP address mode.
CFG Configuration:
network.ip_address_mode
Valid Value:
(0-IPv4;1-IPv6;2-IPv4&IPv6)
Configuration Source Values:
Static: Not Applicable
Default: 0



 

0 Likes