Poly d230 phone set up - Does your phone need to be on same network as main computer for set up? | Community
Skip to main content
A
Newcomer
anickels
Newcomer
December 14, 2022
Solved

Poly d230 phone set up - Does your phone need to be on same network as main computer for set up?

  • December 14, 2022
  • 4 replies
  • 1 view

Hi, 

I am struggling...to say the least. 

My phone is registered in the zoom account. It shows it is  "offline" - so I am assuming need to provision them. I am running into two issues. 1) phone base is saying IP address is 0.0.0.0. 2) when trying to use the provisioning URL provided from zoom to access the web portal for the phone https://provppobi.zoom.us/api/v2/pbx/provisioning/Polycom/d230/${mac}.xml

I get the following error message on the webpage: 

400 Bad Request

No required SSL certificate was sent

I am in a building with other businesses - so I don't have direct access to the building's internet, etc. Not sure what to do. Any guidance would be greatly appreciated. Thanks!

 

 

 

    Best answer by FORE-Craig

    Hi @anickels 

     

    On the handset is there a way to see if DHCP is turned on? I see on the Poly Support site that you can change the setting using the phone's IVR (see attached from link below).

    https://support.polycom.com/content/dam/polycom-support/products/voice/dect-ip-phones/user/en/vvxd230-adminguide-710.pdf

     

    I hope that helps!

     

     

    4 replies

    FORE-Craig
    Specialist
    FORE-Craig
    Specialist
    December 15, 2022

    Hi @anickels 

     

    It seems that the phone is not getting an IP address. Are you trying to connect it via an ethernet cable, or via WiFi?

     

     

    A
    Newcomer
    anickelsAuthor
    Newcomer
    December 15, 2022

    Hi, 

    I am setting it up via ethernet. I am able to use wifi for these phones. 

    I have plugged the phone into the ethernet port - I have factory reset the phone. It is my understanding that I should be getting an IP address on the phone, which I can then use to finish provisioning my phone etc. 

    The IP address is reading 0.0.0.0 and the lights are blinking yellow. I do know this port does work and/or is live, as I have connected to it directly for other things. Thanks for your help!

    A
    Newcomer
    anickelsAuthor
    Newcomer
    December 15, 2022

    I am *not* able to use wifi for these phones. Company policy. 

    E
    Contributor I
    enielsen
    Contributor I
    December 15, 2022

    I've found these particular phones to be a pain to get up and running, I would try setting it up somewhere where you have control over the DHCP if possible the first time. I've always ended up doing multiple factory resets before it works.

    E
    Contributor I
    enielsen
    Contributor I
    December 15, 2022

    Another thing these phones do is that when they can't get DHCP but did in the past, can show the previous IP address even if was from a different location so watch out for that.....

    E
    Contributor I
    enielsen
    Contributor I
    December 15, 2022

    Also, confirm with the team managing dhcp that they don't control access by mac address. Could also be a question of which VLAN the phone is on and/or might have port access controls enabled.

    Terms & ConditionsAccessibility statement
    Copyright © Zoom Communications, Inc. All rights reserved.