cancel
Showing results for 
Search instead for 
Did you mean: 

Yealink T43u not provisioning "no service" after multiple attempts

dselden63
Listener
 
1 ACCEPTED SOLUTION

Eliot
Community Champion | Zoom Partner
Community Champion | Zoom Partner

hi dselden63,

 

begin by adding your phone to the Zoom web portal

Note: Make sure to add your phone to the Zoom web portal before powering on a new phone for the first time or performing a factory reset on a previously-used phone. You can find your phone's model name and MAC address on the label located on the bottom or back of the phone.

Getting started with provisioning desk phones – Zoom Support

 

here are the directions for yealink factory reset

Resetting to factory default (Yealink) – Zoom Support

 

here are yealink troubleshooting directions

Yealink troubleshooting guide – Zoom Support

 

thanks,  eliot

View solution in original post

5 REPLIES 5

Eliot
Community Champion | Zoom Partner
Community Champion | Zoom Partner

hi dselden63,

 

begin by adding your phone to the Zoom web portal

Note: Make sure to add your phone to the Zoom web portal before powering on a new phone for the first time or performing a factory reset on a previously-used phone. You can find your phone's model name and MAC address on the label located on the bottom or back of the phone.

Getting started with provisioning desk phones – Zoom Support

 

here are the directions for yealink factory reset

Resetting to factory default (Yealink) – Zoom Support

 

here are yealink troubleshooting directions

Yealink troubleshooting guide – Zoom Support

 

thanks,  eliot

Thanks Ellot- I have done 10+ factory resets, added the phone to Zoom and tried to auto provision at least a dozen times...still "no service"

Eliot
Community Champion | Zoom Partner
Community Champion | Zoom Partner

sachinzoom
Community Champion | Zoom Employee
Community Champion | Zoom Employee

Hello @dselden63 

 

For ZTP to work on yealink phones,

make sure you have Ports 80,443 open to http://rps.yealink.com

 

Please see this article for more ports to whitelist, if your network is very restricted ( share with your network person 😞

 

Let us know how that goes

 

https://support.yealink.com/en/portal/knowledge/show?id=035c46eea77827eb20d53a4d

 

 

enielsen
Participant

As above -

- check firewall to see if blocking any of the needed traffic

- verify local dhcp not providing parameters overriding the yealink settings

- verify have yealink firmware as specified as needed by zoom (I've not seen this issue on yealink desktop phones, but could happen if is an old phone that has been powered off a long time perhaps?