cancel
Showing results for 
Search instead for 
Did you mean: 

Poly Edge e220 offline

Paul-Varenholt
Newcomer
Newcomer

Just getting started with ZP.

I have had 2 of these phoens go bad on me. Meaning i cannot factory reset them as i've had to RMA them.

The first I thought was a fluke.

The second not so much.  

Have a Reception phone setup as a shared line group.  The phone is part of this line Group.  When I had it setup it was working properly.  Came back from Easter Holiday and red  x through the line appearance. In the phone on ZP Admin it says "

Factory reset needed for provisioning
This device supports zero touch provisioning. After the factory reset is triggered, the process will take a few minutes, please wait until it is finished. If it fails, try Assisted Provisioning."
 
The first phone said this then i added a new phone new mac, etc and it sayss the same thing.
 
Firmware on my working phone is 

 

8.1.0.12774
FIrware on broken phone is 

8.00.13670

 

 

Any thoughts?

Thanks,

Paul.

1 REPLY 1

sachinzoom
Community Champion | Zoom Employee
Community Champion | Zoom Employee

Hi @Paul-Varenholt 

 

The certified version is 8.1.0.12774. When you factory reset it should come back to this version. Are you controlling the firmware version using Company Info -> Account Settings -> Desk phone -> firmware ?